From our design team in Italy — within 24 hours
Trade terms for professionals and design studios
From our design team in Italy — within 24 hours
Trade terms for professionals and design studios
Run a thumb over Cesello and then over Trame, and the difference reaches the hand before the eye has settled. Gessi writes that the three-dimensionality and tactile qualities of these patterns “encourage exploration of the sensory side”, and on Gessi 316 the claim can be tested with the fingertips: raised dots, a spiral, diamonds, a grid. Among stainless steel bath fittings, this is a range meant to be handled as much as seen.
The patterns are pressed into the steel itself, which the catalogue gives as AISI 316 and 316L for the whole collection; Gessi notes that decorations impressed on a noble material gain value on technical objects such as bathroom mixers. Woven metal, as Gessi calls it, arrived with this collection in 2017. In the washroom beside the MD's cabin, the tap is the one surface every visitor actually holds.
Gessi, from Serravalle Sesia, carries the six versions to every point the hand reaches. The lever at the washbasin, low, tall or set in the wall, and at the bidet; the hand shower on the bath rim or the floor column; the valves of the shower, under ceiling systems and heads; the soft rubber hose of the kitchen mixers; holders, rails and a hook; the rim of two steel basins. La Mercanti puts a patterned body and a plain one in the client's hands and lets the fingertips decide.
Share the finishes you wish to evaluate
Gessi describes the Trame decoration as a spiral motif; in the catalogue pictures it reads as fine lines wrapping a tall body. The catalogue groups it with Intreccio for people who like an essential line but want a touch it calls “high-tech but warm and decorative”. Our advice: it suits a washroom where stone and joinery are already plain and the tap can carry the detail.
Two. Gessi lists a deck spout 162 mm tall reaching 156 mm, and a taller one of 231 mm reaching 193 mm, both worked by a separate control. The spout can then sit right above the basin while the control goes where the hand falls naturally, which helps on a wide counter.
For contrast. Gessi describes its three sink mixers as “semi-industrial” taps with a smooth, soft and coloured rubber hose that sets itself against the decorations of the steel. The hose is as visible as the body, so it belongs in the conversation about the kitchen's colours and surfaces, not only in the plumbing schedule.
On the wall, jointed heads of Ø 130, 200 and 300 mm, all anti-limescale, plus the TONDO 200 and 300 rain and cascade systems. From the ceiling, a Ø 300 mm head that can be supplied at a length made to size between 105 and 1,855 mm. Since that dimension follows the ceiling as actually built, it is best confirmed on site once the false ceiling is up.
Three. A four-hole set with spout, diverter, 1.50 m hose and pull-out anti-limescale hand shower; a two-hole set with spout; a three-hole set that delivers water from a column projecting 195 mm. Finishing plates for two, three or four holes go over the built-in box, so the holes drilled in the bath have to match the set chosen.
At the washbasin Gessi 316 offers the same set of mixers in all six versions. Five steps to settle the basin tap, from the waste on the counter to the concealed cartridge in the wall.
The basic Gessi piece is the single-lever deck mixer, offered by Gessi in every version of Gessi 316 either with its own waste or without one. Decide this first: a basin that already has a drain fitting of its own takes the version supplied without waste.
The tall mixer comes with a reach of 123 or 193 mm, or 122 and 198 mm on Tornita. Before choosing, take the distance from the tap base to the middle of the bowl: on a wide vessel basin the longer reach is usually the one that lands the water where it should.
The concealed wall mixer frees the counter entirely. Its spout is 206 or 256 mm long, or made to size anywhere from 70 to 300 mm. Match that length to how far the bowl projects from the wall, and settle it before the tiling begins.
Behind the wall sits a single-outlet concealed mixer with a 35 mm cartridge. It goes in during the wall works, with the plumber, long before the visible lever arrives, so it must appear on the drawings early.
Every one of the six versions offers the same basin pieces: deck, tall, wall-mounted and concealed. The layout of the washroom can therefore be fixed first, and the choice between a plain body and a patterned one made afterwards, once the room is taking shape.